Wolman Woodlife CreoCoat Black Wood Preservative Gallon 14436A

Wolman Woodlife CreoCoat Black Wood Preservative Gallon 14436AWolman Woodlife CreoCoat Wood Preservative is for use on below ground, ground contact or water contact wood installations, especially non pressure treated lumber, to protect the structural integrity. Prevents termite and other insect attack, mold, mildew and other fungi attack, and dimensional change caused by water absorption. Color: Black Base Type: Water Based Product Type: Wood Preservative Container Size: 1 gal Indoor or Outdoor: Outdoor Full

Wolman Woodlife CreoCoat Wood Preservative is for use on below-ground, ground contact or water contact wood installations, especially non-pressure-treated lumber, to protect the structural integrity. Prevents termite and other insect attack, mold, mildew and other fungi attack, and dimensional change caused by water absorption.

• Color: Black
• Base Type: Water-Based
• Product Type: Wood Preservative
• Container Size: 1 gal
• Indoor or Outdoor: Outdoor
• Full Cure Time: 24 hr
• Time Before Recoating: 60 min
• Color Family: Black
• VOC Level: 320 g/L
• Paintable: Yes
• Coverage Area: 200 sq ft
• Transparency: Semi-Transparent
• Form: Liquid
• Container Type: Can
• Collection Type: CreoCoat
  • EPA-registered, insecticidal preservative
  • Prevents termite damage, rot and decay
  • Inhibits surface growth of fungal organisms: mold, mildew and staining fungi
  • Imparts a solid black finish when applied as directed 

  For Best Results

  Preparation is key to maximizing the product’s performance To properly prepare your surface, use either the Wolman™ DeckStrip® or DeckStrip® ASR, then clean with Wolman™ DeckBrite™ or Deck & Fence Brightener.
  If wood is brand new and intended for outdoor installation and exposed to weather conditions for 30 days or less, a “splash test” should be performed to determine if there is any surface barrier present which would repel a new coating. Sprinkle a few drops of water on several areas of the surface to be coated. If the water is absorbed rapidly, the surface is ready to be finished with WOODLIFE^® CreoCoat®. If the water beads are not absorbed into the wood, a surface barrier exists and must be removed. Apply Wolman^® DeckStrip^® or Wolman® Deck & Fence Brightener and then test again. Regardless of the surface’s age or condition, failure to follow proper preparation methods will result in poor adhesion and/or possible coating failure.

Technical Data Sheet