SparkFun Raspberry Pi Zero Case

SparkFun Raspberry Pi Zero CaseThe Raspberry Pi Zero Case has been designed to fit both the Pi Zero and the Pi Zero W. These official cases consist of several parts and protect the Raspberry Pi Zero from things like rogue wires that might short it out while still allowing full access to the board. Simply snap the RPi into the bottom half of the enclosure, then snap on a desired top. No tools required! Each case has a standard base featuring a cut out to allow access to the GPIO,

The Raspberry Pi Zero Case has been designed to fit both the Pi Zero and the Pi Zero W. These official cases consist of several parts and protect the Raspberry Pi Zero from things like rogue wires that might short it out while still allowing full access to the board. Simply snap the RPi into the bottom half of the enclosure, then snap on a desired top. No tools required!

Each case has a standard base featuring a cut-out to allow access to the GPIO, and a choice of three lids: a standard lid, a GPIO lid (allowing access to the GPIO pins from above) and a camera lid (which, when used with the short camera cable supplied, allows the Raspberry Pi camera to be fitted neatly inside it). Additionally, each case includes a 4cm long CSI cable and four rubber feet.

Note: This case does NOT include a Raspberry Pi or Camera Module.

Includes:

• 1x Base
• 1x Standard Lid
• 1x GPIO Lid
• 1x Camera Lid
• 1x Short Camera Cable
• 4x Rubber Feet

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.