Prerunner Series Raised Front Bumper for SCX10/SCX10 II Power Wagon/Nukizer/Honcho/SR5

Prerunner Series Raised Front Bumper for SCX10/SCX10 II Power Wagon/Nukizer/Honcho/SR5ScalerFab Welded Steel Prerunner Series Raised Front Bumper for Axial SCX10 SCX10 II SR5 Honcho Power Wagon Nukizer Also fits the 4 Runner body WITHOUT the plastic front bumper. (Check width measurements and adjust in order notes, if needed) If leaving plastic front bumper, see the XJ Prerunner Series bumper. *Additional Options may be available one our website, www. scalerfab. com Specifications: approx. 190mm wide Requires trimming of plastic bumper

Specifications:

- approx. 190mm wide
- Requires trimming of plastic bumper for Pro-Line SR5 Body
- Bumper Top Plate sites approx. 20mm above the top of the frame rail.
- Includes Pre-drilled mounting holes for winch (RC4WD WARN 9.5cti and 8274 Winch, 3Racing Winch, and SSD Ox Power Winch mounting pattern)
- Mounts using existing holes in frame - does not mount like stock plastic bumper(s) (Longer hardware recommended- hardware not included- See Optional Bumper Hardware Pack available under Accessories)
- Steel construction - Hand Made/Welded.
- Has slots for adjustable fore/aft mounting

**Please Note: Our finish options provide a superficial coating and will scratch/chip under normal use. Pros/cons of each can be found below:

-Raw Steel: We recommend a raw steel finish if you want the scale patina of the bare metal, which will rust over time, or if you intend to coat with a harder finish on your own,

-Flat Black: Superficial matte black coating, will scratch under normal use.

-Rustoleum Truck Bed Coating: OUT OF STOCK/NO LONGER AVAILABLE

Mounting instructions: We recommend removing any plastic cross-members and screwing directly into the frame rails with a nut on the back. For extra tight fit, use a dab of Shoe Goo or E6000 Clear Adhesive between the frame rail and the bracket, and screwing down tight with a nut, and let sit overnight.

*Recommend hardware mounting kits available at the top of the page as an optional add-on.**

Mounting instructions: We recommend removing any plastic cross-members and screwing directly into the frame rails with a nut on the back. For extra tight fit, use a dab of Shoe Goo or E6000 Clear Adhesive between the frame rail and the bracket, and screwing down tight with a nut, and let sit overnight. Recommend hardware mounting kits HERE or at the top of the page as an optional add-on.** Links to additional recommended extras can be found HERE.

Main pic courtesy of @RCbasher83 on IG. #scalerfab for a feature!