Tank Divider for Mr. Deburr DB600 (6.5 Cubic Foot) Machine

Tank Divider for Mr. Deburr DB600 (6.5 Cubic Foot) MachineThe DB600 tank divider makes it easy to: Run multiple batches of parts at the same time Run multiple media sizes and or shapes at the same time Reduce part impingement on soft materials Made in the USA Easy to install at any location Simple and sturdy design and construction Installation Simply decide where you want the divider to be located for your application Place the divider in the chosen location Ensure the notched end at the top fits around the

The DB600 tank divider makes it easy to:

• Run multiple batches of parts at the same time
• Run multiple media sizes and/or shapes at the same time
• Reduce part impingement on soft materials
• Made in the USA
• Easy to install at any location
• Simple and sturdy design and construction

Installation

• Simply decide where you want the divider to be located for your application
• Place the divider in the chosen location
• Ensure the notched end at the top fits around the spray bar that runs across the back of the tank 
• The divider is not meant to sit in between the ribs of the liner
• It should sit on top of the ribs and have a snug fit
• Occasionally the divider may be slightly oversized and difficult to fit.
• In this case lightly sand the edges of the divider until it can be put in place.
• Mark holes to be drilled
• Drill two 5/16” holes
• After drilling holes, fasten in place with included nuts and bolts.
• Note: The set of three pre-drilled holes are used for the sound abatement cover attachment and are not meant for divider mounting

Download Instructions

*Note The Mr Deburr tanks have natural slight variations due to the urethane liner properties. For this reason the divider assemblies will not have an air or liquid tight fit.

**Note Small millimeter sized medias such as porcelain spheres or small parts may pass through or become lodged between the divider and liner in some cases.