Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 14 - Jul 19
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Lemon RX LM0087T DSMP 10ch Telemetry Stabilizer, T-Plug Energy MeterHighlight The generation 2 DSMP 10 channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance. DSMX DSM2 compatible, 10 channel full range telemetry stabilizer with full telemetry features including a built in barometer, altimeter, energy meter (Current, Voltage, mAh), and internal temperature sensor High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane
Highlight
The generation 2 DSMP 10-channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance.
- DSMX / DSM2 compatible, 10-channel full-range telemetry stabilizer with full telemetry features including a built-in barometer, altimeter, energy meter (Current, Voltage, mAh), and internal temperature sensor
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- BEC1 and BEC2 dual inputs allow high-reliability operation while improving setup for high current drain performance servo
- Built-in Delta, V-tail and Normal Wing mixer
- Supports stabilization with separated channel dual aileron operation
- Stabilization always-on feature allows nine usable channels on a 10-channel receiver
- Real-time variable stabilization gain control on channel 8
- All-channel failsafe
- Firmware health monitoring software stack and ultra-low operational voltage (3.6V) ensures high operation reliability
- Generation 2 SDR stack ensures the fastest channel searching and advanced algorithm for signal recovery with ultra-low-latency experience
- Antenna diversity improves the reliability of the wireless link
- Satellite port for additional signal diversity
- Gyro stabilization activation with either AUX2 or Gear channel
- 3 potentiometers for individual gain tuning
User manual
Reset stabilizer
- Connect power
- Hold F and B buttons (approximately 5 secs+) until all LED flashes randomly
- Press the C button. Multiple LEDs flash a few times to complete the operation
Bind with bind plug
- Insert bind plug on Channel 10
- Connect power
Bind without bind plug
- Connect power
- Hold the B button until the red LED flashes
Bind with a satellite without a bind plug
- Connect power
- Hold the B button until the red LED flashes
- Disconnect power
- Plug the satellite wire connector into the stabilizer
- Connect power
Failsafe
- Connect power to the receiver and ensure the servos are working with the transmitter
- Press the F button for 3 seconds until green changes from off to on and vice versa to change the failsafe setting. Channel value is saved as failsafe default at the time the green LED turns on.
- Turn off the transmitter and wait 2 seconds to ensure the failsafe is activated accordingly by ensuring there is torque generated with finger-pushing the servo linkage if it was to be set. Vice versa.
Stabilization activation switch
- Disconnect power
- Insert bind plug to channel 8
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash.
- Release the C button
- Press C to make changes within 3 seconds. Green = CH7, Blue = CH5.
- Wait for 3 seconds and remove the bind plug
Wing Mode and Dual Aileron
- Disconnect power
- Insert bind plug to channel 9
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash
- Check the receiver label/user manual to understand the referred LEDs' operation
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug
- Ensure transmitter mixing is set accordingly for dual aileron if stabilized dual aileron is to be configured.
Gyro direction
- Check the receiver label/user manual to understand the referred LEDs' operation
- Connect power and wait 1 second
- Hold the C button and wait for about 1 second until the 6 LEDs flash
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug.
V/I sensor calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected.
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Turn on the DC loading device by throttling the transmitter. Ensure 4A is drawing across the V/I sensor. Be careful with the motor spinning if it is to be used.
- Press the B button to save and exit.
V/I probe calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected.
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Press the B button to save and exit.
Gain setting
- Adjust via the 3 dials or real-time master gain on channel 8 depending on the transmitter channel's availability.
View setting LEDs with all on
- Press the C button briefly (no more than 2 seconds).
Lemon Rx products are tested to be compatible with Spektrum's DSMX and or DSM2 product (Spektrum, DSMX and DSM2 are the registered trademark of Horizon Hobby, Inc.).
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.7 ★★★★★
Based on 2228 reviews
Sort
Product Reviews
★★★★★ 3
Our dog loves it but it wasn’t durable enough to last
Color: Dogwood Jack, Size: Large, Color: Dogwood Jack, Size: Large
Our lab took to it as soon as we gave it to her. Perfect size for our 80 lb yellow lab.
However, now that it’s in about 10 days, she’s able to break off chunks from this bone that are dime size or larger, and we have to throw it away
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 1, 2026
★★★★★ 5
No problems after a year and a half
Color: Dogwood & Calming, Size: Medium
Have been regularly buying these for my corgi for about a year and a half. The 2 pack lasts about a month or 2 each time. Pieces break off in small enough pieces that they safely pass through his digestive system. He gnaws each one down to about 1/4 the original size before we take it away and give him a new one. He continues to have regular bowel movements and has a healthy appetite so I can’t imagine any problems arising after so long.
I have tried other alternatives and every other similar chew breaks off in larger pieces and didn’t feel comfortable letting him chew/eat them. I noticed there are a few 1 star reviews saying their dogs got sick off these but after a year and a half I have had 0 issues with this product. I guess it depends on the dog and how big of pieces they are swallowing. My dog ingests pieces about the size of a grain of rice so just pay attention and you should be fine.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 18, 2026
★★★★★ 5
Long lasting and safer alternative to sticks
Color: Dogwood & Calming, Size: Medium
These are great, very durable, and have lasted a very long time. Much safer for my dogs than the random sticks they find in the yard. They do get shorter with chewing eventually, but they don't break off in little chunks like I've seen with some nylon chews, and they don't splinter like wood. Medium size works well for both my 16 lb Cavalier and my 60 lb Pyrenees/Golden mix. They're both moderate-to-aggressive chewers, though size obviously affects how much damage they can do.
I wish you could buy the hemp chew separately because that one is very much a favorite in my house, so after 2 years and 2 purchases, I have barely any left of the remaining hemp chew, but still 2 of the dogwood chews that neither dog is as interested in anymore. I'd love to buy a couple more of just the hemp one.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 30, 2026
★★★★★ 5
Your dog will thank you.
Color: Dogwood & Fresh Breath, Size: Large
My dogs loves to chew on these. They make a small mess but not as bad as other chews. They are food for keeping teeth clean.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 31, 2026
★★★★★ 5
Nice chew toy
Color: Dogwood Mushroom, Size: Medium, Color: Dogwood Mushroom, Size: Medium
Super durable and puppy loves it. It was a bit hard for her at first but now at 5 months it’s one of her favorite things to gnaw on! It is heavy for the size but seems to be great quality and has given many hours of chew time with minimal wear.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 12, 2026
recommand products
Vintage Colony Park Lane Glasses / Dessert Cups - Set of 6
33.99
Vintage Etched Glasses- Set of 4 (Set #4007)
45.99
Mercury-Mercruiser 8M0085858 1100 17.00R405B18
4180.00
Vintage HC Fry Blue Stemmed Optic Spiral Glasses - Set of 10
149.99
Vintage Imperial Glass Candlewick Beaded Edge Candle Holders (circa 1936 - 1984) - Set of 2
26.99