Pay in installments of $468.74 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 3 - Aug 8
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
2022-2025 Toyota Tundra 1.25-3.25 Inch Lift 2023-2025 Sequoia 3-4.25 Inch Lift V.S. 3.0 Series Front Coilover Kit Remote Reservoir W CDXS Pair Icon Vehicle DynamicsICON's 3. 0 Series Coilovers with CDXS for 2022 2025 Toyota Tundra and 2023 2025 Toyota Sequoia are designed to take the off road capability of the trucks to new levels by increasing wheel travel by up to 40 Percent and significantly improving the damping ability of the front shocks. Features and Benefits: 3. 0 Series shocks boast 50 Percent more piston surface area in the ride zone of the shock's travel, and 100 Percent in the InchBump Zone Inch,
ICON's 3.0 Series Coilovers with CDXS for 2022-2025 Toyota Tundra and 2023-2025 Toyota Sequoia are designed to take the off-road capability of the trucks to new levels by increasing wheel travel by up to 40 Percent and significantly improving the damping ability of the front shocks.
Features and Benefits:- 3.0 Series shocks boast 50 Percent more piston surface area in the ride zone of the shock's travel, and 100 Percent in the InchBump Zone Inch, compared to 2.5 Series shocks. This translates into increased stability and vehicle control at the extremes of off-road use, with benefits also making themselves apparent in on-road driving conditions. The multi-stage hydraulic Bump Zone featured in these 3.0 Series shocks exponentially increases bottom-out resistance as the shock travels through the last 40 Percent of travel, keeping vehicle dynamics in check during those hard hits or unexpected obstacles.
- ICON's exclusive Compression Damping Dual Speed (CDXS) valves are included for precisely dialing in your suspension performance. CDXS controls fluid flow under compression, with independent adjustability of high speed and low speed compression force. 10 discreet detented settings for both low and high-speed adjustment knobs allow separate adjustments for handling response and overall aggressiveness. When paired with ICON 3.0 Series rear shocks with CDXS, vehicle control can be precisely dialed in front to rear, resulting in the best overall driving experience.
- These 3.0 Series coilovers are designed as an OEM shock replacement, making installation a simple and straightforward bolt-on affair. Built-in ride height adjustability yields 1.25 to 3.25 Inch of front lift height on Tundra or 3-4.25 Inch of lift on Sequoia allowing for the fitment of larger, more aggressive wheel and tire combinations. First class ICON manufacturing processes and quality components are used to ensure these shocks function to their maximum potential without issue.
- 40 Percent increase in front wheel travel over stock
- Adjustable up to 1.25-3.25 Inch of front lift height over stock on Tundra or 3-4.25 Inch of front lift on Sequoia
- Vehicle specific design and tuning for superior shock damping and control
- 3.0 Inch Body diameter for increased oil volume and larger piston area
- ICON's multi-stage, tunable hydraulic InchBump Zone Inch exponentially increases bottom-out resistance in the last 40 Percent of compression travel
- ICON CDXS equipped for independent adjustability of high speed and low speed compression force for handling response and aggressiveness
- CNC machined 6061 aluminum components with a black anodized finish
- PTFE lined spherical bearings for extended longevity and minimal deflection
- 7/8 Inch diameter induction hardened, chrome plated shock shafts
- Fully Rebuildable and Re-tunable
- Material: Steel, Aluminum
- Active Or Passive Suspension: Passive
- Adjustable Compression: Yes
- Adjustable Damping: Yes
- Adjustable Rebound: No
- Adjustable Ride Height: Yes
- Assembled: Yes
- Body Diameter: 3 Inch
- Coil Over Springs Included: Yes
- Compressed Length: 16.38
- Cylinder Color: Gray
- Cylinder Finish: Ceramic Coated
- Cylinder Material: Steel
- Damping Adjustment Type: Dual Speed/Manual
- Damping Type: Oil
- Dust Shield: No
- Dust Shield Included: No
- Extended Length: 22.04
- Front Spring Rate: 600 Inch
- Gas Charged: Yes
- Grade Type: Performance
- Includes Bump Stop: No
- Internal Construction Type: Single Tube
- Lower Mount Type: Eyelet
- Maximum Lift: 3.25 Inch
- Maximum Ride Height Raising Distance: 3.25
- Minimum Lift: 1.25 Inch
- Remote Reservoir: Yes
- Reservoir Style: Remote
- Self Leveling: No
- Service Parts: 254100G - 1 Gallon Icon Performance Shock Oil
- Shaft Diameter: 0.875
- Shock Absorber Body End Measuring Point: Top Of Upper Mount Plate
- Shock Absorber Rod End Measuring Point: Center Of Eyelet
- Spring Color: Black
- Spring Material: Steel
- Spring Rate Type: Linear
- Travel Length: 5.67
- Upper Mount Type: Mounting Plate
- Valving Type: Digressive, Linear
- Add On Part: 58461Dj - 22-25 Tundra/23-25 Sequoia Tubular UCA Dj Pro Kit, 198001 - Billet Spanner Wrench Kit, 252012 - -4 To -10 Hose Shield Kit, 58561Dj - 22-25 Tundra/23-25 Sequoia Billet UCA Dj Pro Kit, 198000 - 2 Pin Coilover Spanner Wrench Kit, 191010 - Icon Raptor 3.0 Coil Wrap W/Logo Pair, 55164 - 22-25 Tundra/23-24 Sequoia Aluminum Skid Plate Spacer Kit, 55154 - 22-25 Tundra/23-25 Sequoia Sway Bar Drop Kit
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.1 ★★★★★
Based on 8 reviews
Sort
Product Reviews
★★★★★ 1
Do not buy
Color: Silver
The worst frother i've ever used. You can't even turn it off without having to go through all the different modes, meaning you will get absolutely splashed and have to clean all the little droplets of whatever you were frothing. The power is weak. The battery did last a long time, I'll give them that. 3 months ON THE DAY the frother stopped working. A very loud noise and decreased power made it unusable. I sent them an email with NO response.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 28, 2026
★★★★★ 5
Mixes drinks well and holds a charge
Color: Silver
I bought this frother to replace a weaker frother I had been using for months. I make iced lattes with instant espresso powder, water, and milk, and this frother does a great job at mixing the powder into the water/milk. It also leaves a nice 1" or so of milk froth on the top. I love that it can be charged with a USB-C cable and doesn't require batteries like many frothers do. It's very powerful for the size.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 7, 2026
★★★★★ 5
Putting my $.02 into the mix
Size: Basic Frother, Color: Black
My old, lame hand mixer finally gave up the ghost. I ordered one of those “stick blenders” but it was waaaay too powerful for my purposes. (I don’t need it to dice/chop/pulverize fruits or veggies - if you need that, this mixer isn’t for you.) I needed something in between. I kept coming back to the “milk frothers,” but I had my doubts that one of those could mix up my morning shake. I tried a frother some years ago, and it wasn’t designed for blending ingredients, just for frothing liquids. Still, I had an idea (like some of you might) that what I needed was not a true stick mixer, nor a true milk frother. Something in between. I needed a “frother on steroids.”
I settled on this one-the YUSWKO YW-218. It had the regular frothing head, but also two other heads. One looks like a mini bread hook; the other like a mini whisk.
I plugged it into charge and it did take the stated time to come to a full charge. (Like any kid with a new toy, I tried turning it on before charging, but the low state of charge resulted in the high-medium-low settings not behaving correctly.)
For my first few forays into blending, I tried the mini bread hook thingee. It worked OK, but not as well nor as quickly as I wanted. I then shifted to the mini whisk thingee. I didn’t really prepare well. I combined my milk-protein powder-carnation breakfast-malt flavoring-imitation (yeah, I know, it probably causes cancer, but only in California) vanilla flavoring concoction into my normal medium-sized concession cup (you know, the smaller ones you get at high school basketball games), lowered the whisk head into the goop, and turned it to “low.” In a second, I was wearing my shake. But the power capacity was more than enough to do what I was needing.
Anyway, since that first attempt with the whisk head, I’ve gotten the routine down. And it is EXACTLY what I needed. (I’ll try to attach a video to show you.). Clean up is simple. You can do it with soapy water and a brush or rag, but I just run the thing in clear water and ensure I get all the sticky stuff off. I tried the soapy water, but I got a LOT of suds.
A few pointers. First, charge it up all the way before using it. I haven’t had to recharge for two weeks now. You’ll use a regular, small phone-charging brick. (Two words of CAUTION. I found that the included, cheap charging cord did not work. It got really hot, like there was an electrical short in it. So I found one of my own. Also, DO NOT USE the larger charging blocks like the ones from Ap*le. I tried and it was too much.) Second, I assumed that the low speed would be the less aggressive and thus the less “throw-stuff-out-of-the-cup” setting. But that hasn’t proven true for me. I’ve found that the medium setting makes my ingredients behave better (less throw-out and quicker blending). Experiment with different speeds, even though it may not make immediate sense. Third, practice with plain water first (I’ve already told you how I know this). That’ll give you a “feel” for what this frother will do. Fourth, practice with different sized cups. I’ve since changed to the taller concession cups, as they prevent throw-out. Fifth, start practicing with your cups down in a sink. Less mess to clean up and no need to change clothes before you head out to work or school (I’m a teacher). Finally, familiarize yourself with the way the three buttons work. My previous mixer required me to keep the button depressed to blend. If I let up on the button, the unit would stop. Not so with this one. A light press to start, let go, then a light press to stop. Don’t keep mashing the button.
Final thoughts: this frother is just what I needed. If your experience sounds like mine, I think this one’ll give you good service.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 25, 2022
★★★★★ 5
Excellent frother
Size: Basic Frother, Color: Christmas Red
This item works great! I love the red color and how easy it is to clean, and howneasynitnis to charge. I also like that there are three different attachments to choose from.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 8, 2026
★★★★★ 5
Perfect and convenient tool
Size: Basic Frother, Color: Black
I am very happy with my new milk frother. Really easy to use and I was very pleased with the results. I got to enjoy my first home made cappuccino and it was perfect. I have only used the frother attachment so far but I plan to use the whip the next time I scramble a couple of eggs. Very please with my purchase.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 3, 2026
recommand products
2-1/2" - 3" EXTEND-O-DRAIN
10.12
NONWOVEN FLEECE FILTER BAGS FOR TURBO I (5/PK)
44.95
Gold Quartz Mens Ring "Orocal" RM962Q Genuine Hand Crafted Jewelry - 14K Gold Casting
2823.99
Gold Quartz Ladies Ring "Orocal" RL560Q Genuine Hand Crafted Jewelry - 14K Gold Casting
1068.80
SINGLE POCKET TOOL POUCH
15.80