MRT 2 -Wire Transponder

MRT 2 -Wire TransponderWorks great with mylaps. MRT Transponder, mPTX ID 100% waterproofThese transponders from MRT are lightweight and small in size. This makes them easy to fit into the smallest, tightest areas. Size: 19 x 16 x 6mmWeight: 4 gramsThe PTX ID number of each transponder can be changed to an alternative ID number. Each individually numbered transponder has its 'custom' ID number written on the supplied instruction sheet with the an alternative number also

Works great with mylaps.
MRT Transponder, mPTX-ID 100% waterproof

These transponders from MRT are lightweight and small in size. This makes them easy to fit into the smallest, tightest areas.
Size: 19 x 16 x 6mm
Weight: 4 grams

The PTX ID number of each transponder can be changed to an alternative ID number. Each individually numbered transponder has its 'custom' ID number written on the supplied instruction sheet with the an alternative number also available.

PTX transponders are supplied with 2 stored ID numbers and come factory set on the custom ID. It is possible to switch from the custom number to the other number if required. To use the PTX it should be connected to a power socket on a receiver or to a battery pack. The LED will light up to show the transponder is operating. When setting the number (or checking the number that is set) the LED will flash to show the number selected, or the number that has been set.

Operating Voltage: 2.1V - 16V DC
Lead Length: about 190mm
Mounting: Standard 3 Hole (same as AMB/MyLaps)
Compatibility: AMBrc2, AMBrc3 and RC4 systems.